H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 630)

65-2
When the device functions as the SFTP server, only one client can access the SFTP server at a time. If
the SFTP client uses WinSCP, a file on the server cannot be modified directly; it can only be
downloaded to a local place, modified, and then uploaded to the server.
Configuring the SFTP Connection Idle Timeout Period
Once the idle period of an SFTP connection exceeds the specified threshold, the system automatically
tears the connection down, so that a user cannot occupy a connection for nothing.
Follow these steps to configure the SFTP connection idle timeout period:
To do… Use the command… Remarks
Enter system view system-view —
Configure the SFTP connection
idle timeout period sftp server idle-timeout
time-out-value
Required
10 minutes by default
Configuring an SFTP Client
Specifying a Source IP Address or Interface for the SFTP Client
You can configure a client to use only a specified source IP address or interface to access the SFTP
server, thus enhancing the service manageability.
Follow these steps to specify a source IP address or interface for the SFTP client:
To do… Use the command… Remarks
Enter system view system-view —
Specify a source IPv4
address or interface for the
SFTP client
sftp client source { ip
ip-address | interface
interface-type
interface-number }
Specify a
source IP
address or
interface for the
SFTP client
Specify a source IPv6
address or interface for the
SFTP client sftp client ipv6 source
{ ipv6 ipv6-address |
interface interface-type
interface-number }
Required
Use either command.
By default, an SFTP client
uses the interface address
specified by the route of the
device to access the SFTP
server.
Establishing a Connection to the SFTP Server
This configuration task is to enable the SFTP client to establish a connection with the remote SFTP
server and enter SFTP client view.
Follow these steps to enable the SFTP client: