H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 40)

2-10
To do… Use the command… Remarks
Set the maximum number
of lines the screen can
contain
screen-length screen-length
Optional
By default, the screen can contain up to 24
lines.
You can use the screen-length 0 command
to disable the function to display information in
pages.
Set history command
buffer size history-command max-size
value
Optional
The default history command buffer size is 10.
That is, a history command buffer can store up
to 10 commands by default.
Set the timeout time for the
user interface idle-timeout minutes
[ seconds ]
Optional
The default timeout time of a user interface is
10 minutes.
With the timeout time being 10 minutes, the
connection to a user interface is terminated if
no operation is performed in the user interface
within 10 minutes.
You can use the idle-timeout 0 command to
disable the timeout function.
Note that if you configure to authenticate the users in the scheme mode, the command level available to
users logging in to the access controller switch interface board depends on the authentication-mode
scheme [ command-authorization ] command, the user privilege level level command, and the
service-type telnet [ level level ] command, as listed in Table 2-6 .