H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 528)

56-8
For an H3C WX6103 access controller switch interface board, the file to be backed up or restored is the
main configuration file for next startup.
Backing up the configuration file for next startup
To do… Use the command… Remarks
Back up the configuration file for
next startup backup startup-configuration to
dest-addr
[ filename ]
Required
Available in user view
Before backup, you should:
z
Ensure that the server is reachable, the server is enabled with TFTP service, and the client has
permission to read and write.
z
Use the display startup command (in user view) to verify if you have set the startup configuration
file, and use the dir command to verify if this file exists. If the file is set as NULL or does not exist,
the backup will be unsuccessful.
Restoring the startup configuration file
To do… Use the command… Remarks
Restore the startup configuration
file restore startup-configuration
from src-addr filename
Required
Available in user view
z
Before restoring a configuration file, you should ensure that the server is reachable, the server is
enabled with TFTP service, and the client has permission to read and write.
z
After the command is successfully executed, you can use the display startup command (in user
view) to verify if the filename of the startup configuration file is the same with the filename argument,
and use the dir command to verify if the restored file exists.