H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 135)

17-4
form one link connected to AC B and performs load sharing among these ports.
Network diagram
Figure 17-1 Network diagram for link aggregation configuration
AC A
Link aggregation
AC B
GE
0/0/1
GE
0/0/2
GE
0/0/3
Configuration procedure
This example only describes how to configure link aggregation on AC A. To achieve link aggregation,
do the same on AC B.
1) In manual aggregation approach
# Create manual aggregation group 1.
<AC A> system-view
[AC A] link-aggregation group 1 mode manual
# Add ports GigabitEthernet 0/0/1 through GigabitEthernet 0/0/3 to the group.
[AC A] interface GigabitEthernet 0/0/1
[AC A-GigabitEthernet0/0/1] port link-aggregation group 1
[AC A-GigabitEthernet0/0/1] interface GigabitEthernet 0/0/2
[AC A-GigabitEthernet0/0/2] port link-aggregation group 1
[AC A-GigabitEthernet0/0/2] interface GigabitEthernet 0/0/3
[AC A-GigabitEthernet0/0/3] port link-aggregation group 1
2) In static aggregation approach
# Create static aggregation group 1.
<AC A> system-view
[AC A] link-aggregation group 1 mode static
# Add ports GigabitEthernet 0/0/1 through GigabitEthernet 0/0/3 to the group.
[AC A] interface GigabitEthernet 0/0/1
[AC A-GigabitEthernet0/0/1] port link-aggregation group 1
[AC A-GigabitEthernet0/0/1] interface GigabitEthernet 0/0/2
[AC A-GigabitEthernet0/0/2] port link-aggregation group 1
[AC A-GigabitEthernet0/0/2] interface GigabitEthernet 0/0/3
[AC A-GigabitEthernet0/0/3] port link-aggregation group 1