H3C Technologies H3C WX3000 Series Unified Switches - Manual (Page 233)

23-16
To do… Use the command… Remarks
In system view
dot1x supp-proxy-check { logoff
| trap } [ interface interface-list ]
interface interface-type
interface-number
dot1x supp-proxy-check { logoff
| trap }
Enable proxy
checking for a
port/specified
ports
In port view
quit
Required
By default, the 802.1x proxy
checking is disabled on a port.
z
The proxy checking function needs the cooperation of an 802.1x client program.
z
The proxy checking function depends on the online user handshaking function. To enable the
proxy detecting function, you need to enable the online user handshaking function first.
z
The configuration listed in the table above takes effect only when it is performed on CAMS as well
as on the device. In addition, the client version checking function needs to be enabled on the
device too (by using the dot1x version-check command).
Configuring Client Version Checking
Follow these steps to configure client version checking:
To do… Use the command… Remarks
Enter system view system-view —
In system view
dot1x version-check
[ interface interface-list ]
interface interface-type
interface-number
dot1x version-check
Enable 802.1x
client version
checking
In port view
quit
Required
By default, 802.1x client version
checking is disabled on a port.
Set the maximum number of
retires to send version checking
request packets
dot1x retry-version-max
max-retry-version-value
Optional
By default, the maximum number of
retires to send version checking
request packets is 3.
Set the client version checking
period timer dot1x timer ver-period
ver-period-value
Optional
By default, the timer is set to 30
seconds.