H3C Technologies H3C WX3000 Series Unified Switches - Manual (Page 436)

44-6
Configuring Timers
This section describes how to configure the aging timer of the router port, the aging timer of the
multicast member ports, and the query response timer.
Follow these steps to configure timers:
To do… Use the command… Remarks
Enter system view system-view —
Configure the aging timer of the
router port igmp-snooping
router-aging-time
seconds
Optional
By default, the aging time of the
router port is 105 seconds.
Configure the query response
timer igmp-snooping
max-response-time
seconds
Optional
By default, the query response
timeout time is 10 seconds.
Configure the aging timer of the
multicast member port igmp-snooping host-aging-time
seconds
Optional
By default, the aging time of
multicast member ports is 260
seconds
Configuring Fast Leave Processing
With fast leave processing enabled, when the device receives an IGMP leave message on a port, the
device directly removes that port from the forwarding table entry for the specific group. If only one host
is attached to the port, enable fast leave processing to improve bandwidth management.
Enabling fast leave processing in system view
Follow these steps to enable fast leave processing in system view:
To do… Use the command… Remarks
Enter system view system -view —
Enable fast leave processing
igmp-snooping fast-leave [ vlan
vlan-list ]
Required
By default, the fast leave
processing feature is disabled.
Enabling fast leave processing in Ethernet port view
Follow these steps to enable fast leave processing in Ethernet view:
To do… Use the command… Remarks
Enter system view system -view —
Enter Ethernet port view
interface interface-type
interface-number
—
Enable fast leave processing for
specific VLANs igmp-snooping fast-leave [ vlan
vlan-list ]
Required
By default, the fast leave
processing feature is disabled.