H3C Technologies H3C WX3000 Series Unified Switches - Manual (Page 581)

58-2
Figure 58-1 HWPing illustration
Switch A Switch B
HWPing Client
IP network
HWPing Server
Test Types Supported by HWPing
Table 58-1 Test types supported by HWPing
Supported test types Description
ICMP test
DHCP test
FTP test
HTTP test
DNS test
SNMP test
For these types of tests, you need to configure HWPing client and
corresponding servers.
Jitter test
Tcppublic test
TCP test
Tcpprivate test
Udppublic test
UDP test
Udpprivate test
z
These types of tests need the cooperation of HWPing client and
HWPing Server.
z Do not perform TCP or UDP test on port 1 to 1023 (well-known
ports). Otherwise your HWPing test may fail or cause the service
corresponding to the well-known port (1 to 1023) being unavailable.
HWPing Test Parameters
You need to configure corresponding test parameters for each type of HWPing test. HWPing test
parameters can be configured on HWPing client only. For the configurations on HWPing client, refer to
section.
Table 58-2 HWPing test parameters
Test parameter Description
Destination address (destination-ip)
For TCP/UDP/jitter test, you must specify a destination IP
address, and the destination address must be the IP address of a
TCP/UDP/UDP listening service configured on the HWPing
server.
Destination port (destination-port)
For tcpprivate/udpprivate/jitter test, you must specify a
destination port number, and the destination port number must
be the port number of a TCP or UDP listening service configured
on the HWPing server.