H3C Technologies H3C WX3000 Series Unified Switches - Manual (Page 88)

11-7
For the operation of adding a hybrid port to a VLAN in the untagged way (when forwarding a packet, the
port removes the VLAN tag of the packet), refer to the section of configuring Ethernet ports in Port Basic
Configuration in H3C WX3000 Series Unified Switches Switching Engine Configuration Guide.
Displaying and Maintaining Protocol-Based VLAN
To do… Use the command… Remarks
Display the information about the
protocol-based VLAN display vlan [ vlan-id [ to vlan-id ] | all |
dynamic | static]
Display the protocol information and
protocol indexes configured on the
specified VLAN
display protocol-vlan vlan { vlan-id [ to
vlan -id ] | all }
Display the protocol information and
protocol indexes configured on the
specified port display protocol-vlan interface
{ interface-type interface-number [ to
interface-type interface-number
] | all }
Available in any view
Protocol-Based VLAN Configuration Example
Network requirements
z
As shown in Figure 11-2 , Workroom connects to the LAN through port GigabitEthernet 1/0/10 on
the switch.
z
IP network and AppleTalk network workstations (hosts) coexist in the Workroom.
z
The switch connects to VLAN 100 (using IP network) through GigabitEthernet 1/0/11 and to VLAN
200 (using AppleTalk network) through GigabitEthernet 1/0/12.
z
Configure the switch to automatically assign the IP and AppleTalk packets to proper VLANs for
transmission, so as to ensure the normal communication between the workstations and servers.