H3C Technologies H3C WX3000 Series Unified Switches User Manual
Page 502
46-30
[device] user-interface vty 0 4
[device-ui-vty0-4] authentication-mode scheme
# Enable the user interfaces to support SSH.
[device-ui-vty0-4] protocol inbound ssh
[device-ui-vty0-4] quit
# Create local user “client001”, and set the authentication password to abc, the login protocol to SSH,
and user command privilege level to 3.
[device] local-user client001
[device-luser-client001] password simple abc
[device-luser-client001] service-type ssh level 3
[device-luser-client001] quit
# Configure the authentication type of user client001 as password.
[device] ssh user client001 authentication-type password
z
Configure Switch A
# Create a VLAN interface on the device and assign an IP address, which serves as the SSH client’s
address in an SSH connection.
<device> system-view
[device] interface vlan-interface 1
[device-Vlan-interface1] ip address 10.165.87.137 255.255.255.0
[device-Vlan-interface1] quit
# Establish a connection to the server 10.165.87.136.
[device] ssh2 10.165.87.136
Username: client001
Trying 10.165.87.136 ...
Press CTRL+K to abort
Connected to 10.165.87.136 ...
The Server is not authenticated. Do you continue to access it?(Y/N):y
Do you want to save the server's public key?(Y/N):n
Enter password:
**************************************************************************
* Copyright(c) 2004-2007 Hangzhou H3C Tech. Co., Ltd. All rights reserved. *
* Without the owner's prior written consent, *
* no decompiling or reverse-engineering shall be allowed. *
**************************************************************************
<device>
When the Device Acts as an SSH Client and the Authentication Type is Publickey
Network requirements
As shown in
, establish an SSH connection between Switch A (SSH Client) and Switch B
(SSH Server) for secure data exchange. The user name is client001 and the SSH server’s IP address is
10.165.87.136. Publickey authentication is required.