H3C Technologies H3C WX3000 Series Unified Switches - Manual (Page 373)

37-29
Configuration example
Enable the burst function on the devicees.
Configuration procedure:
<device> system-view
[device] burst-mode enable
Configuring Traffic Mirroring
Refer to Traffic mirroring for information about traffic mirroring.
Configuration prerequisites
z
The ACL rules for traffic classification are defined. Refer to ACL in H3C WX3000 Series Unified
Switches Switching Engine Configuration Guide for information about defining ACL rules.
z
The source mirroring ports and mirroring direction are determined.
z
The destination mirroring port is determined.
Configuration procedure
You can configure traffic mirroring on all the packets matching specific ACL rules, or on packets that
match specific ACL rules and are of a VLAN, of a port group, or pass a port.
Follow these steps to configure traffic mirroring globally:
To do… Use the command… Remarks
Enter system view system-view —
Enter Ethernet port view of the destination port
interface interface-type
interface-number
—
Define the current port as the destination port monitor-port Required
Exit current view quit —
Reference ACLs for identifying traffic flows and
perform traffic mirroring for packets that match. mirrored-to inbound acl-rule
monitor-interface
Required
Follow these steps to configure traffic mirroring for a VLAN:
To do… Use the command… Remarks
Enter system view system-view —
Enter Ethernet port view of the destination port
interface interface-type
interface-number
—
Define the current port as the destination port monitor-port Required
Exit current view quit —
Reference ACLs for identifying traffic flows and
perform traffic mirroring for packets that match. mirrored-to vlan vlan-id inbound
acl-rule monitor-interface
Required
Follow these steps to configure traffic mirroring for a port group:
To do… Use the command… Remarks
Enter system view system-view —
Enter Ethernet port view of the destination
port interface interface-type
interface-number
—