Intel NETWORK PROCESSOR IXP2800 - Manual (Page 170)

170 Hardware Reference Manual
Intel
®
IXP2800 Network Processor
Microengines
The Microengine is in Idle state whenever no Context is running (all Contexts are in either Inactive
or Sleep states). This state is entered:
1. After reset (because CTX_Enable Local CSR is clear, putting all Contexts into Inactive states).
2. When a context swap is executed, but no context is ready to wakeup.
3. When a
ctx_arb[bpt]
instruction is executed by the Microengine (this is a special case of
condition 2 above, since the
ctx_arb[bpt]
clears CTX_Enable, putting all Contexts into
Inactive states).
The Microengine provides the following functionality during Idle state:
1. The Microengine continuously checks if a Context is in Ready state. If so, a new Context
begins to execute. If no Context is Ready, the Microengine remains in the Idle state.
2. Only the ALU instructions are supported. They are used for debug via special hardware
defined in number 3 below.
3. A write to the Ustore_Addr Local CSR with the Ustore_Addr[ECS] bit set, causing the
Microengine to repeatedly execute the instruction pointed by the address specified in the
Ustore_Addr CSR. Only the ALU instructions are supported in this mode. Also, the result of
the execution is written to the ALU_Out Local CSR rather than a destination register.
4. A write to the Ustore_Addr Local CSR with the Ustore_Addr[ECS] bit set, followed by a
write to the Ustore_Data Local CSR loads an instruction into the Control Store. After the
Control Store is loaded, execution proceeds as described in number 3 above. Note that the
write to Ustore_Data causes Ustore_Addr to increment, so it must be written back to the
address of the desired instruction.
Figure 57. Context State Transition Diagram
A9352-03
Inactive Ready
CTX_ENABLE bit is set by
Intel XScale ® Core
CTX_ENABLE bit is cleared
CTX_ENABLE
bit is cleared
Reset
Sleep Executing
Context executes
CTX Arbitration instruction
Executing Context goes
to Sleep state, and this
Context is the highest
round-robin priority.
Ex
ter
na
l E
ven
t S
ign
al a
rrive
s
Note:
After reset, the Intel XScale
® Core processor must load the starting address of the CTX_PC, load the
CTX_WAKEUP_EVENTS to 0x1 (voluntary), and then set the appropriate CTX_ENABLE bits to begin
executing Context(s).