Intel NETWORK PROCESSOR IXP2800 - Manual (Page 421)

Hardware Reference Manual 421
Intel
®
IXP2800 Network Processor
Performance Monitor Unit
11.4.6.25 SRAM CH2 Events Target ID(001100) / Design Block #(0010)
11.4.6.26 SRAM CH1 Events Target ID(001101) / Design Block #(0010)
Table 179. SRAM CH3 PMU Event List
Event
Number
Event Name
Clock
Domain
Pulse/
Level
Burst Description
Note:
1. All the SRAM Channel has same event lists.
2. S_CLK = SRAM clock domain
3. P_CLK = PP clock domain
signals that begin with sps_ correspond to S_Push Arb
signals that begin with spl_ correspond to S-Pull Arb
signals that contain _pc_ (after the unit designation) correspond to the PCI target interface
signals that contain _m_ (after the unit designation) correspond to the MSF target interface
signals that contain _sh_ (after the unit designation) correspond to the SHaC target interface
signals that contain _s0_ (after the unit designation) correspond to the SRAM0 target interface
signals that contain _s1_ (after the unit designation) correspond to the SRAM1 target interface
signals that contain _s2_ (after the unit designation) correspond to the SRAM2 target interface
signals that contain _s3_ (after the unit designation) correspond to the SRAM3 target interface
Table 180. SRAM CH3 PMU Event List
Event
Number
Event Name
Clock
Domain
Pulse/
Level
Burst Description
Note:
1. All the SRAM Channel has same event lists.
2. S_CLK = SRAM clock domain
3. P_CLK = PP clock domain
signals that begin with sps_ correspond to S-Push Arb
signals that begin with spl_ correspond to S-Pull Arb
signals that contain _pc_ (after the unit designation) correspond to the PCI target interface
signals that contain _m_ (after the unit designation) correspond to the MSF target interface
signals that contain _sh_ (after the unit designation) correspond to the SHaC target interface
signals that contain _s0_ (after the unit designation) correspond to the SRAM0 target interface
signals that contain _s1_ (after the unit designation) correspond to the SRAM1 target interface
signals that contain _s2_ (after the unit designation) correspond to the SRAM2 target interface
signals that contain _s3_ (after the unit designation) correspond to the SRAM3 target interface