Konica Minolta bizhub PRESS C8000e - Manual (Page 247)

bizhub PRESS C8000/e 6-31
6.8 Loading Paper 6
6.8.3 Loading Paper in Paper Feeder Unit (Trays 4 to 9)
The paper feeder unit is of the following two models.
- Paper Feeder Unit PF-704 (trays 4 to 9)
- Paper Feeder Unit (with scanner) PF-705 (trays 4 to 6)
To use paper other than loaded in a tray, change the setting of that tray in [Paper Setting] from the Machine
Screen or Copy Screen.
1
Withdraw the tray to be supplied with paper.
NOTICE
Trays cannot be withdrawn when the machine is not powered.
Be sure to turn the sub power switch ON.
NOTICE
Only one tray can be withdrawn at a time.
To load a different size of paper, proceed to step 2.
To load the same size as loaded before, proceed to step 5.
2
Fully widen the side guides and rear guide.
% Turn the two guide fixing knobs of the side guides counter-
clockwise to loosen them.
% Fully widen the side guides and rear guide while pressing
the lock release lever of the side guides and rear guide.
NOTICE
When moving the side guides, be sure to hold the lock release
lever of the front side guide and the handle of the rear guide. If
moved only with the front side guide, the side guides may not
be fixed in position.
3
Align the side guides to the paper.
% Load about 100 sheets of paper. While pushing the lock re-
lease lever of the front side guide, align both side guides to
the paper and position them according to the paper size in-
dicator provided on the guide holding plate.
NOTICE
The two side guides are provided with small size guides. Be
sure to open them only when loading paper of the width less
than 182 mm.
NOTICE
Do not open only a half of them to load paper.
For usage of small size guides, see page 6-35.