Konica Minolta bizhub PRESS C8000e - Manual (Page 361)

bizhub PRESS C8000/e 9-43
9.7 [03 Finisher Adjustment] (Saddle Stitcher SD-506) 9
10
Press [Return] to restore the Saddle Stitcher Adjustment Menu Screen.
9.7.2 [06 Saddle Stitcher Pos. Adj.] - [02 Staple Paper Width Adj.]
Adjust the width of adjustment plates of Saddle Stitcher SD-506 to be used in Staple mode.
Objects of adjustment: Full Area, SRA3 w, A3 w, B4 w, SRA4 w, A4 w, B5 w, 13 e 19 w, 12 e 18 w,
11 e 17 w, 8.5 e 14 w, 8.5 e 11 w, 8.125 e 13.25 w, 8.5 e 13 w, 8.25 e 13 w, 8 e 13 w, 8K w, 16K w,
Custom (380-463 mm), Custom (257-379 mm)
NOTICE
With [Full Area] selected, the entered value will be applied to all sizes. With a specific paper size selected, set
value will be the sum of the entered value and the value previously specified for [Full Area].
1
Press [Adjustment] on the Machine Screen to display the Adjustment Menu Screen.
2
Press [03 Finisher Adjustment], [06 Saddle Stitcher Pos. Adj.], and [02 Staple Paper Width Adj.] in se-
quence.
The Staple Paper Width Adjustment Screen will be displayed.
3
Select the size to be adjusted using [+] and [,] to scroll.
4
Press [Print Mode].
5
Load the paper size to be adjusted into a tray, then select that tray key.
6
Press Start on the control panel. A sample pattern will be output.
7
Check if the stapled set shows misalignment (a) (caused if specified paper width is larger than the actual
width), or is curved (b) (caused if specified paper width is smaller than the actual width).
Allowance: a = 1 mm or less
8
If any adjustment is required, press [Exit Print Mode] to return to the Staple Paper Width Adjustment
Screen.