Konica Minolta bizhub PRESS C8000e - Manual (Page 346)

9.5 [03 Finisher Adjustment] (Folding Unit FD-503) 9
bizhub PRESS C8000/e 9-28
8
If any adjustment is required, press [Exit Print Mode] to return to the Paper Width Adjustment Screen.
9
Use the touch panel keypad or control panel keypad to enter the setting data.
% Use [+/-] to specify the value to be positive or negative.
% Press [Set] to change the current data.
% Adjustable range: -20 (Narrow) to +20 (Wide) (1 step = 0.1 mm)
% Adjusting the width too wide may dislocate the center position of punch holes, or adjusting it too
narrow may change the position of punch holes variously.
10
Repeat the steps from 4 to 9 until the desired result is obtained.
11
Press [Return] to restore the Multi Folder (Punch) Adjustment Menu Screen.
9.5.2 [02 Multi Folder (Punch) Adj.] - [02 Punch Vertical Position Adj.]
Adjust the vertical position of punch holes made by Folding Unit FD-503. Adjust the distance between punch
holes and the edge of paper.
Objects of adjustment: 2-Hole Punch--Full Area, A3 w, B4 w, SRA4 w, A4 w/v, B5 w/v, A5 w/v, 12 e 18 w,
11 e 17 w, 8.5 e 14 w, 8.5 e 11 w/v, 8.125 e 13.25 w, 8.5 e 13 w, 8.25 e 13 w, 8 e 13 w, 8K w, 16K w/v,
9 e 11 v
4-Hole Punch: Full Area, A3 w, B4 w, SRA4 w, A4 v, B5 v, 12 e 18 w, 11 e 17 w, 8.5 e 11 v, 8K w, 16K v,
9 e 11 v
NOTICE
With [Full Area] selected, the entered value will be applied to all sizes. With a specific paper size selected, set
value will be the sum of the entered value and the value previously specified for [Full Area].
1
Press [Adjustment] on the Machine Screen to display the Adjustment Menu Screen.
2
Press [03 Finisher Adjustment], [02 Multi Folder (Punch) Adj.], and [02 Punch Vertical Position Adj.] in
sequence.
3
Select either [01 2-Hole Punch] or [02 4-Hole Punch].
4
Select the size to be adjusted using [+] and [,] to scroll.
5
Press [Print Mode].
6
Load the paper size to be adjusted into a tray, then select that tray key.
7
Press Start on the control panel. A sample pattern will be output.