Konica Minolta bizhub PRESS C8000e - Manual (Page 386)

9.9 [03 Finisher Adjustment] (Finisher FS-612) 9
bizhub PRESS C8000/e 9-68
11
Press [Return] to restore the Punch Adjustment Menu Screen.
9.9.5 [03 Punch Adjustment] - [03 Registration Adjustment]
Adjust the registration amount if punch holes are positioned obliquely when using Finisher FS-612.
Objects of adjustment: Main Body/Reverse, Main Body/ADU, PI 1 Tray, PI 2 Tray
1
Press [Adjustment] on the Machine Screen to display the Adjustment Menu Screen.
2
Press [03 Finisher Adjustment], [03 Punch Adjustment], and [03 Registration Adjustment] in sequence.
The Registration Adjustment Screen will be displayed.
3
Press the key of the item to be adjusted.
4
Press [Print Mode].
5
Select the tray loaded with paper.
6
Press Start on the control panel. A sample pattern will be output.
7
Check if the punch holes are skew on the output sheet.
8
If any adjustment is required, press [Exit Print Mode] to return to the Registration Adjustment Screen.
9
Use the touch panel keypad or control panel keypad to enter the setting data.
% Use [+/-] to specify the value to be positive or negative.
% Press [Set] to change the current data.
% Adjustable range: -20 to +20 (1 step = 0.8 mm)
10
Repeat the steps from 4 to 9 until the desired result is obtained.
11
Press [Return] to restore the Punch Adjustment Menu Screen.