Konica Minolta bizhub PRESS C8000e - Manual (Page 344)

9.4 [03 Finisher Adjustment] (Finisher FS-521) 9
bizhub PRESS C8000/e 9-26
1
Press [Adjustment] on the Machine Screen to display the Adjustment Menu Screen.
2
Press [03 Finisher Adjustment], [01 Staple Finisher Adjustment], and [05 Exit Guide Paper Width Adj.]
in sequence.
The Exit Guide Paper Width Adjustment Screen will be displayed.
3
Select the size to be adjusted using [+] and [,] to scroll.
4
Press [Print Mode].
5
Load the paper size to be adjusted into a tray, then select that tray key.
6
Press Start on the control panel. A sample pattern will be output.
7
Check the misalignment (a) of the sheets delivered to the primary (main) tray.
Check the gap between output sheets and exit guides in operation to estimate the adjustment data
from it.
8
If any adjustment is required, press [Exit Print Mode] to return to the Exit Guide Paper Width Adjustment
Screen.
9
Use the touch panel keypad or control panel keypad to enter the setting data.
% Use [+/-] to specify the value to be positive or negative.
% Press [Set] to change the current data.
% Adjustable range: -50 (Wide) to +50 (Narrow) (1 step = 0.1 mm)
% If the width is adjusted too narrow, output sheets may be misaligned in vertical scanning direction.
10
Repeat the steps from 4 to 9 until the desired result is obtained.
11
Press [Return] to restore the Staple Finisher Adjustment Menu Screen.