Konica Minolta bizhub PRESS C8000e - Manual (Page 566)

11.4 [Controller] - [03 System Setting] 11
bizhub PRESS C8000/e 11-20
List of Software Switch Setting
Switch No. Problem/Requirement Solution reached when turned On
1 When choosing the PDF direct print, the
paper size should be identified by using the
CropBox value (trimmed size), instead of
using the MediaBox value as is normally
the case. The paper size will be identified by using
the CropBox value (trimmed size) for the
PDF file.
2 When using the LPR command to group
multiple jobs as a single print job, the oper-
ation terminates with an error and does not
complete the output. Regardless of the spool setting for the
Controller, the job will be executed upon
receiving the entire data (file). Note that
this setting may slow down the printing
performance.
Important:
When changing this setting, make sure
to turn off the main power switch and
then turn it back on in order to retain the
setting.
The maximum file size transmittable for
this operation is 2 GB for each file. The
change of this setting will not affect other
larger files.
3 When attempting to output an unsupport-
ed compressed TIFF file or PDL file, the
cause of the error is not reported. An error page will be printed out on re-
ceiving a job for an unsupported file.
Important:
For PostScript errors, select [Controller] -
[Direct Print] - [PS Settings] from the Ma-
chine Screen to specify the output set-
tings.
4 When outputting PostScript data over the
network, multiple jobs are grouped as a
single job. Ctrl-D will be taken as a job delimiter,
and data will be output as multiple jobs.
5 When outputting PostScript data over a
USB interface, a single job is divided into
multiple jobs. Or, an error page may be
output instead. Ctrl-D will not be taken as a job delimiter,
and data will be output as a single job.
6 Outputting files containing colored images
results in poor halftone reproducibility. Colored images will be converted to
monochrome halftone images more ef-
fectively, enhancing the reproducibility of
the output. Note that this setting may
slow down the printing performance.
7 When outputting multiple jobs as one col-
lective file, whether or not to output the file
as multiple jobs should be selectable by
treating PJL JOBNAME and PJL EOJ
NAME commands as separators. Options:
Off: Output as a file without separating it
On: Output as multiple jobs
8/9 When using the direct print to output a TIFF
file created by scanning standard size orig-
inals or TIFF file of a standard size created
using an application, the machine prompts
for a custom paper size. Changing the tolerance in detecting pa-
per size enables the output of a TIFF file
slightly different in size using a standard
paper size.
Options:
8/9 = Off/Off: +0.9 mm to -4.0 mm
8/9 = On/Off: +0.9 mm to -10.0 mm
8/9 = Off/On: +0.9 mm to -0.9 mm
10 Any job whose output size is not set can
only be output in the original size. Through specifying a tray, the output will
be fit to the size of the paper mounted in
that tray.
11 The Auto setting of the machine for paper
feed should invariably be used. Paper feed will always be managed using
the Auto setting of the machine, regard-
less of the tray settings from the printer
driver.
12 The job list on the machine should display
file names specified in the LPR command
as job names. The job list will display file names speci-
fied in the LPR command as job names.