Konica Minolta bizhub PRESS C8000e - Manual (Page 486)

10.7 [02 Administrator Setting] - [01 System Setting] 10
bizhub PRESS C8000/e 10-72
3
Select the item to be adjusted.
4
Use the touch panel keypad or control panel keypad to enter the setting data.
% Use [+/-] to specify the value to be positive or negative.
% Press [Set] to change the current data.
5
Press [Return] to restore the Process Adjustment Menu Screen.
10.7.17 [04/05 Expert Adjustment] - [03 Process Adjustment] - [02 Toner Density
Sensor Speed]
Readjust the value of toner density control voltage in line speeds 2 and 3 in order to clear the problems such
as image overlap or toner scattering, mainly caused by instability of toner density.
NOTICE
The title number given to [Expert Adjustment] will be [04] for the machine without Image Controller IC-601,
or [05] for the machine with that option mounted.
1
Follow the procedure on page 10-3 to display the Administrator Setting Menu Screen.
2
Press [01 System Setting], [04/05 Expert Adjustment], [03 Process Adjustment], and [02 Toner Density
Sensor Speed] in sequence.
3
Press [Start] to display the adjustment values.
% To cancel the checking operation, press [Stop].
4
Press [Return] to restore the Process Adjustment Menu Screen.
10.7.18 [04/05 Expert Adjustment] - [03 Process Adjustment] - [03 Maximum Density
Adjustment]
Adjust the maximum density for each of Y, M, C, and K.
NOTICE
The machine will start the Gamma Automatic Adjustment after you change the maximum density and exit the
Utility mode. When the Gamma Automatic Adjustment is completed, proceed to the calibration with the print-
er controller.
Be sure to perform Color Density Manual Control after changing the maximum density.
NOTICE
The title number given to [Expert Adjustment] will be [04] for the machine without Image Controller IC-601,
or [05] for the machine with that option mounted.
Adjustable range: -10 (Light) to +10 (Dark) for each of Yellow, Magenta, Cyan, and Black