Konica Minolta bizhub PRESS C8000e - Manual (Page 341)

bizhub PRESS C8000/e 9-23
9.4 [03 Finisher Adjustment] (Finisher FS-521) 9
4
Press [Print Mode].
5
Load the paper size to be adjusted into a tray, then select that tray key.
6
Press Start on the control panel. A sample pattern will be output.
7
Open the finisher door, and then withdraw the staple unit.
% When using paper with a length of 239 mm or longer, the staple unit cannot be withdrawn. Remove
the output paper from the delivery end, withdraw the staple unit, and then reset the paper in the unit.
8
Check the gap between adjustment plates and output paper.
Check if the stapled set shows misalignment (a) (caused if specified paper width is larger than the actual
width), or is curved (b) (caused if specified paper width is smaller than the actual width).
9
Remove the paper from the staple unit, return the staple unit to its original position, then close the fin-
isher door.
10
If any adjustment is required, press [Exit Print Mode] to return to the Paper Width Adjustment (Straight)
Screen.
11
Use the touch panel keypad or control panel keypad to enter the setting data.
% Use [+/-] to specify the value to be positive or negative.
% Press [Set] to change the current data.
% Adjustable range: -20 (Wide) to +20 (Narrow) (1 step = 0.1 mm)
12
Repeat the steps from 4 to 11 until the desired result is obtained.
13
Press [Return] to restore the Staple Finisher Adjustment Menu Screen.
9.4.4 [01 Staple Finisher Adjustment] - [04 Exit Guide Center Pos. Adj.]
Align the center position of exit guides of Finisher FS-521 to the center line of paper.
Objects of adjustment: Straight (Small), Straight (Large), Shift Front (Small), Shift Front (Large), Shift Back
(Small), Shift Back (Large)
NOTICE
Perform [01 Staple Finisher Adjustment] - [05 Exit Guide Paper Width Adj.] along with this adjustment.