Konica Minolta bizhub PRESS C8000e - Manual (Page 265)

bizhub PRESS C8000/e 6-49
6.14 Removing Finished Sets from Large Capacity Stacker LS-505 6
6.14 Removing Finished Sets from Large Capacity Stacker LS-505
Large Capacity Stacker LS-505 can hold 5,000 output sheets at maximum (3,000 sheets for coated paper
of max. 331 mm e 483 mm to min. 210 mm e 380 mm/2,000 sheets for B5 and A5).
Follow the procedure below to take out paper from the stacker.
6.14.1 Removing Finished Sets from the Stacker
1
Press the paper removal button.
The stacker unit will move down to the carriage.
% The paper stopper is provided to secure the paper in posi-
tion when moving the carriage. See page 6-50 for usage of
the paper stopper.
2
Open the large capacity stacker door.
% Once the stacker holds a sheet of output paper, the large
capacity stacker door will be locked and cannot open till the
stacker unit goes down fully to the carriage.
3
Withdraw the carriage by holding its handle.
NOTICE
Be sure to withdraw the carriage straightforward. Do not change
the direction forcibly while driving it. The carriage is for the ex-
clusive use of carrying paper. Do not drive it in any other use.
Never put yourself in the large capacity stacker.
4
Remove paper from the carriage.
The stacker unit can be removed from the carriage.
NOTICE
Once lowering the stacker unit for the purpose of removing mis-
handled paper or checking output sheets, copying cannot be
started till output sheets are removed. If the carriage is returned
with any sheets left on the stacker unit, machine trouble may be
caused. Be sure to remove all the sheets.