Konica Minolta bizhub PRESS C8000e - Manual (Page 316)

8.7 Troubleshooting Tips 8
bizhub PRESS C8000/e 8-38
F
inisher FS-521
Finisher FS-521
does not operate. Is any mishandled paper left inside
the Finisher FS-521? Check for paper misfeed and re-
move it, as required.
Is finisher door slightly open? Securely close the finisher door.
Output sheets
skew in the sets
and cannot be sta-
pled in position. Is paper excessively curled? Reload the paper upside down into
the tray.
Paper misfeed fre-
quently occurs in-
side Finisher FS-
521. Are the side guides of the selected
tray aligned to paper? Make sure the side guides are se-
curely aligned to paper in the tray to
be used.
Using Punch
mode, printed
sheets cannot be
punched. Does the Punch-Hole Scraps Box
indicator light on the Machine
Screen? Empty the scrap box.
Printed sheets can-
not be stapled in
position. Is paper excessively curled? Reload the paper upside down into
the tray.
Printed sheets can-
not be delivered
neatly to the sec-
ondary (sub) tray. Do output sheets reach to the edge
of the secondary (sub) tray? Temporarily release the lock of the
secondary (sub) tray so that the
secondary (sub) tray should be
raised slightly.
Saddle Stitcher SD-506
Using trimming
function, printed
sheets cannot be
trimmed. Does the Saddle Stitcher Trim
Scrap indicator light on the Machine
Screen? Empty the scrap box of Saddle
Stitcher SD-506, or contact your
service representative.
Perf
ect Binder
PB-503
Using Perfect Bind
mode, printed
sheets cannot be
bound. Does the front door, perfect binder
tray cover, or glue hopper cover of
Perfect Binder PB-503 open? Securely close the front door, per-
fect binder tray cover, and glue
hopper cover of Perfect Binder
PB-503.
F
inisher FS-612
Finisher does not
operate. Is any mishandled paper left inside
the finisher? Check for paper misfeed and re-
move it, as required.
Is finisher front door slightly open? Securely close the finisher front
door.
Printed sheets
skew in the output
sets and cannot be
stapled or punched
in position. Is paper excessively curled? Reload the paper upside down into
the tray.
Are the side guides of the selected
tray (or paper guides of PI tray)
aligned to paper? Make sure the side guides (or pa-
per guides) are securely aligned to
paper in the tray to be used.
Using Punch
mode, printed
sheets cannot be
punched. Does the Punch-Hole Scraps Box
indicator light on the Machine
Screen? Empty the scrap box of the punch
kit.
Printed sheets can-
not be stapled in
position. Is paper excessively curled? Reload the paper upside down into
the tray.
Case Checkpoint Remedy