Konica Minolta bizhub PRESS C8000e - Manual (Page 382)

9.9 [03 Finisher Adjustment] (Finisher FS-612) 9
bizhub PRESS C8000/e 9-64
9.9 [03 Finisher Adjustment] (Finisher FS-612)
9.9.1 [01 Saddle Stitcher Stopper]
Adjust the dislocation of staple positions in widthwise direction of paper using Fold & Staple mode operated
by Finisher FS-612.
Objects of adjustment: Full Area, A3 w, B4 w, SRA4 w, A4 w, 12 e 18 w, 11 e 17 w, 8.5 e 14 w, 8.5 e 11 w,
8.125 e 13.25 w, 8.5 e 13 w, 8.25 e 13 w, 8 e 13 w, 8K w, 16K w, Custom (380-460 mm), Custom (220-
379 mm)
1
Press [Adjustment] on the Machine Screen to display the Adjustment Menu Screen.
2
Press [03 Finisher Adjustment] and [01 Saddle Stitcher Stopper] in sequence.
3
Select the size to be adjusted using [+] and [,] to scroll.
4
Press [Print Mode].
5
Load the paper size to be adjusted into a tray, then select that tray key.
6
Press Start on the control panel. A sample pattern will be output.
7
Check the misalignment of the center fold and the position of staples on the output sheet.
Allowance: a = 0 +/- 1 mm
8
If any adjustment is required, press [Exit Print Mode] to return to the Fold & Staple Stopper Adjustment
Screen.
9
Use the touch panel keypad or control panel keypad to enter the setting data.
% Use [+/-] to specify the value to be positive or negative.
% Press [Set] to change the current data.
% Adjustable range: -128 (Bottom) to +127 (Top) (1 step = 0.1 mm)
% Enter a negative value for (a), or a positive value for (b).
10
Repeat the steps from 4 to 9 until the desired result is obtained.