Konica Minolta bizhub PRESS C8000e - Manual (Page 212)

5.10 Using Perfect Binder PB-503 5
bizhub PRESS C8000/e 5-72
%
When the Perfect Binder PB-503 become available, this message is changed to [PB Heater].
d
Reference
The heater of the perfect binder can be set to start warming up automatically with the sub power switch
turned on. Contact your service representative, if desired.
NOTICE
Once started, the warmup of the heater will not be interrupted even when the Auto Low Power/ Auto Shut Off
functions on the main body. Once [Perfect Bind] selected on the Output Setting Screen, the heater of the per-
fect binder will continue warming up even though the setting is canceled with [Function Off] pressed on the
Perfect Binding Screen or with Reset pressed on the control panel. If not using the Perfect Binder PB-503,
be sure to turn off the heater by pressing the heater switch of the perfect binder [OFF] on the Machine Screen.
To turn off the heater of the perfect binder
When the job using perfect binder is completed, the heater of the perfect binder will automatically be turned
off in one minute.
The heater will also be turned off automatically in one minute if any operation has not been made on the Per-
fect Binder PB-503 after completion of the warmup.
The heater can be turned off manually by pressing the heater switch for the perfect binder [OFF] on the Ma-
chine Screen while warming up or ready for operation.
Pressing the heater switch for the perfect binder [OFF] will not function if any perfect binding jobs are entered.
d
Reference
Service can set the heater not to be turned off automatically after one-minute interval. Contact your service
representative, if desired. In this case, the heater will not be turned off till the Auto Low Power/Auto Shut Off
functions on the main body. Please be careful not to allow the glue pellets to deteriorate.