Konica Minolta bizhub PRESS C8000e - Manual (Page 249)

bizhub PRESS C8000/e 6-33
6.8 Loading Paper 6
6.8.4 Making Fine Adjustment on Side Guides of Paper Feeder Unit (Trays 4 to 9)
The paper feeder unit is of the following two models.
- Paper Feeder Unit PF-704 (trays 4 to 9)
- Paper Feeder Unit (with scanner) PF-705 (trays 4 to 6)
If front and rear side guides are not fixed upright, in other words, any gap is found between top and bottom
edges of the side guides, feeding trouble may be caused. In this case, follow the adjustment procedure below
to properly fix the top and bottom edges of the side guides.
1
Withdraw the tray to be adjusted.
% Trays cannot be withdrawn when the machine is not pow-
ered. Be sure to turn the sub power switch ON.
2
Fully widen the side guides and rear guide.
% Turn the two guide fixing knobs of the side guides counter-
clockwise to loosen them.
% Fully widen the side guides and rear guide while pressing
the lock release lever of the side guides and rear guide.
NOTICE
When moving the side guides, be sure to hold the lock release
lever of the front side guide and the handle of the rear guide. If
moved only with the front side guide, the side guides may not
be fixed in position.
3
Load paper of the size to be adjusted.
% Load about 100 sheets of paper.
4
Fix the position of bottom edges of side guides.
% Pushing the lock release lever of the front side guide, move
the side guides to align them to the paper.
NOTICE
Avoid making the space between the side guides too wide or
too narrow for the paper to be seated straight.
NOTICE
When moving the side guides, be sure to hold the lock release
lever of the front side guide and the handle of the rear guide. If
moved only with the front side guide, the side guides may not
be fixed in position.