Konica Minolta bizhub PRESS C8000e - Manual (Page 286)

8.2 If [Mishandled paper] Message Is Displayed 8
bizhub PRESS C8000/e 8-8
8.2.1 To Remove Mishandled Paper
1
Press [Illustration] on the screen.
The screen illustrating the method for the disposal action will be displayed.
% Press [Next] to go to the next page of a series of illustrations, if provided.
% Press [Jam Position] to return to the Jam Position Screen.
2
Follow the instruction on the screen to remove mishandled paper.
NOTICE
Before performing the clearing procedure, be sure to check the caution label locations inside the ma-
chine. For details, see "Safety Information."
3
When completed, the Machine Screen will be restored.
If any misfeed location is left, the Jam Position Screen will be restored with the next disposal procedure
in the message area and the location number in the jam position display. Repeat steps 1 to 2 until all
the locations are cleared. When all procedures for removing paper have been completed, it returns to
the Machine Screen.
7CAUTION
DO NOT put your hand into the fusing part on the left side of the fixing unit.
- Otherwise, you may get burned. Be especially careful when removing mishandled paper.
7CAUTION
DO NOT put your hand or arm between the main body and the fixing conveyance unit.
- Connecting terminals of electric parts are located on the rear side of the fixing conveyance unit, and
touching them may damage the machine. Also, if you put your hand or arm between the main body and
the fixing conveyance unit, unexpected trouble may be caused. Please do not try to work yourself, but
contact your service representative.
7CAUTION
Removing Stuck Staples
Staples are very sharp!
- Be careful of removing staples stuck inside the machine so as not to get injured.
7CAUTION
DO NOT touch the fusing device of the 2nd fusing unit.
- The top surface and both right and left sides of the fusing device are very hot. If you touch them, you
may get burned. Please be especially careful in withdrawing the fusing device.
7CAUTION
DO NOT put your hand or arm between the main body and 2nd fusing unit.
- If you put your hand or arm between the main body and 2nd fusing unit, unexpected trouble may be
caused. Please do not try to work yourself, but contact your service representative.