Konica Minolta bizhub PRESS C8000e - Manual (Page 331)

bizhub PRESS C8000/e 9-13
9.2 [01 Machine Adjustment] 9
9
Use the touch panel keypad or control panel keypad to enter the setting data.
% Use [+/-] to specify the value to be positive or negative.
% Press [Set] to change the current data.
% Adjustable range: -60 (Lower) to +60 (Higher) (1 step = 0.1 mm)
10
Repeat the steps from 4 to 9 until the desired result is obtained.
11
Press [Return] to restore the Printer Adjustment Menu Screen.
9.2.2 [01 Printer Adjustment] - [02 Centering Adjustment]
Adjust the image position in crosswise direction in the printer engine.
Objects of adjustment: Tray 1 to Tray 9, ADU, Large Size Offset (Tray 1 to Tray 9), Small Size Offset (Tray 1
to Tray 9), 8.5 e 5.5 Offset (Tray 1 to Tray 3), Large Plain Offset (ADU), Large Thick Offset (ADU), Small Plain
Offset (ADU), Small Thick Offset (ADU), 8.5 e 5.5 Plain Offset (ADU), 8.5 e 5.5 Thick Offset (ADU)
NOTICE
Make this adjustment after completing [04 CD-Mag. Adjustment].
d
Reference
An identification mark can be printed on sample patterns to identify the sides of paper and used paper tray.
For details, please contact your service representative.
1
Press [Adjustment] on the Machine Screen to display the Adjustment Menu Screen.
2
Press [01 Machine Adjustment], [01 Printer Adjustment], and [02 Centering Adjustment] in sequence.
The Centering Adjustment Screen will be displayed.
3
Press the key of the object to be adjusted.
4
Press [Print Mode].
5
Load A3 w paper into the tray to be adjusted, then select that tray key.
6
Press Start on the control panel. A sample pattern will be output.
7
Fold the output sheet at the center in the paper feed direction, and check the misalignment of the center
line of the print and folded line.
Allowance: within 0 +/- 1.5 mm
8
If any adjustment is required, press [Exit Print Mode] to return to the Centering Adjustment Screen.