Konica Minolta bizhub PRESS C8000e - Manual (Page 340)

9.4 [03 Finisher Adjustment] (Finisher FS-521) 9
bizhub PRESS C8000/e 9-22
8
Check the gap between adjustment plates and output paper.
Check if the stapled set shows misalignment (a) (caused if specified paper width is larger than the actual
width), or is curved (b) (caused if specified paper width is smaller than the actual width).
9
Remove the paper from the staple unit, return the staple unit to its original position, then close the fin-
isher door.
10
If any adjustment is required, press [Exit Print Mode] to return to the Paper Width Adjustment (Staple)
Screen.
11
Use the touch panel keypad or control panel keypad to enter the setting data.
% Use [+/-] to specify the value to be positive or negative.
% Press [Set] to change the current data.
% Adjustable range: -20 (Wide) to +20 (Narrow) (1 step = 0.1 mm)
12
Repeat the steps from 4 to 11 until the desired result is obtained.
13
Press [Return] to restore the Staple Finisher Adjustment Menu Screen.
9.4.3 [01 Staple Finisher Adjustment] - [03 Paper Width Adj. (Straight)]
Adjust the width of stacker adjustment plates of the finisher to be used in straight delivery.
Objects of adjustment: Full Area, SRA3 w, A3 w, B4 w, SRA4 w/v, A4 w/v, B5 v, A5 v, 12 e 18 w, 11 e 17
w, 8.5 e 14 w, 8.5 e 11 w/v, 8.125 e 13.25 w, 8.5 e 13 w, 8.25 e 13 w, 8 e 13 w, 8K w, 16K v, 9 e 11 v,
Custom (380-460 mm), Custom (220-379 mm), Custom (148-219 mm)
NOTICE
With [Full Area] selected, the entered value will be applied to all sizes. With a specific paper size selected, set
value will be the sum of the entered value and the value previously specified for [Full Area].
1
Press [Adjustment] on the Machine Screen to display the Adjustment Menu Screen.
2
Press [03 Finisher Adjustment], [01 Staple Finisher Adjustment], and then [03 Paper Width (Straight)].
The Paper Width Adjustment (Straight) Screen will be displayed.
3
Select the size to be adjusted using [+] and [,] to scroll.