Konica Minolta bizhub PRESS C8000e - Manual (Page 343)

bizhub PRESS C8000/e 9-25
9.4 [03 Finisher Adjustment] (Finisher FS-521) 9
7
Check the misalignment (a) of the sheets delivered to the primary (main) tray.
Check the gap between output sheets and exit guides in operation to estimate the adjustment data
from it.
8
If any adjustment is required, press [Exit Print Mode] to return to the Exit Guide Center Position Adjust-
ment Screen.
9
Use the touch panel keypad or control panel keypad to enter the setting data.
% Use [+/-] to specify the value to be positive or negative.
% Press [Set] to change the current data.
% Adjustable range: -50 (Forward) to +50 (Backward) (1 step = 0.1 mm)
NOTICE
For straight delivery, specify the same adjustment data for both small and large sizes.
The adjustment data of straight delivery will not be reflected in the shift amount of shift delivery.
With excessively estimated data specified, exit guides may interfere with output sheets in delivery. When
making this adjustment, be sure to check the operation of exit guides.
When making an adjustment for shift delivery, be sure neither to have a space along the fixed exit guide,
nor to give any stress to output sheets.
10
Repeat the steps from 4 to 9 until the desired result is obtained.
11
Press [Return] to restore the Staple Finisher Adjustment Menu Screen.
9.4.5 [01 Staple Finisher Adjustment] - [05 Exit Guide Paper Width Adj.]
Adjust the width of exit guides of Finisher FS-521.
Objects of adjustment: Full Area, SRA3 w, A3 w, B4 w, SRA4 w/v, A4 w/v, B5 v, A5 v, 12 e 18 w,
11 e 17 w, 8.5 e 14 w, 8.5 e 11 w/v, 8.125 e 13.25 w, 8.5 e 13 w, 8.25 e 13 w, 8 e 13 w, 8K w, 16K v,
9 e 11 v, Custom (380-460 mm), Custom (220-379 mm), Custom (148-219 mm)
NOTICE
Perform [01 Staple Finisher Adjustment] - [04 Exit Guide Center Pos. Adj.] along with this adjustment.
NOTICE
This adjustment is effective against the paper with a width in horizontal scanning direction of 182 mm (B5 w )
or more in straight delivery, or 210 mm (A4 w ) or more in shift delivery. Small sizes such as A5 w , B6 w , or
5.5 e 8.5 w are unavailable because adjustment guides will not operate for those small sizes.
NOTICE
With [Full Area] selected, the entered value will be applied to all sizes. With a specific paper size selected, set
value will be the sum of the entered value and the value previously specified for [Full Area].