Konica Minolta bizhub PRESS C8000e - Manual (Page 353)

bizhub PRESS C8000/e 9-35
9.5 [03 Finisher Adjustment] (Folding Unit FD-503) 9
8
If any adjustment is required, press [Exit Print Mode] to return to the Double Parallel Position Adjust-
ment Screen.
9
Select [Single Fold].
10
Use the touch panel keypad or control panel keypad to enter the setting data.
% Use [+/-] to specify the value to be positive or negative.
% Press [Set] to change the current data.
% Adjustable range: -50 (Long) to +50 (Short) (1 step = 0.1 mm)
% The measurement (a) in step 7 will decrease with positive value entered, and increase with negative
value entered.
11
Select [Double Fold].
12
Repeat step 10.
% The measurement (b) in step 7 will decrease with positive value entered, and increase with negative
value entered.
13
Repeat the steps from 4 to 12 until the desired result is obtained.
14
Press [Return] to restore the Multi Folder (Fold) Adjustment Menu Screen.
9.5.7 [03 Multi Folder (Fold) Adj.] - [05 Z-Fold Position Adj.]
Adjust the folded positions in Z-Fold mode determined by Folding Unit FD-503.
Objects of adjustment: Full Area, A3 w, B4 w, SRA4 w, A4 w, 12 e 18 w, 11 e 17 w, 8.5 e 14 w, 8.5 e 11 w,
8K w, Custom (380-458 mm), Custom (279-379 mm)
NOTICE
When adjusting both Single Fold and Double Fold, be sure to start with the Single Fold adjustment. The po-
sition of Single Fold is calculated from the edge of the sheet, while that of Double Fold is calculated from the
position of Single Fold. Consequently, the measurement (b) in step 7 is subject to the change in either position
of the fold.
NOTICE
With [Full Area] selected, the entered value will be applied to all sizes. With a specific paper size selected, set
value will be the sum of the entered value and the value previously specified for [Full Area].
[1] Single Fold [2] Double Fold