Konica Minolta bizhub PRESS C8000e - Manual (Page 368)

9.7 [03 Finisher Adjustment] (Saddle Stitcher SD-506) 9
bizhub PRESS C8000/e 9-50
7
Check the trimming width (a) of the output sheets.
Allowance: a = 2 mm or more
8
If any adjustment is required, press [Exit Print Mode] to return to the Trimming Adjustment Screen.
9
Use the touch panel keypad or control panel keypad to enter the setting data.
% Use [+/-] to specify the value to be positive or negative.
% Press [Set] to change the current data.
% Adjustable range: -400 (Short) to +400 (Long) (1 step = 0.1 mm)
% Enter the value so that the cover should be cut by 2.0 mm or more. If the trimming width is less than
2.0 mm, the trimming operation may not performed properly.
10
Repeat the steps from 4 to 9 until the desired result is obtained.
11
Press [Return] to restore the Saddle Stitcher Adjustment Menu Screen.
9.7.8 [06 Saddle Stitcher Pos. Adj.] - [08 Trimmer Receiver Adj.]
Frequent trimming operations may cause damage to the receiver, resulting in trimming failures.
Trim Count: Select the count of trimming operations to move the receiver periodically.
Move Pitch: Select the pitch to move the receiver.
Execute Compulsive Movement: Manually move the receiver.
NOTICE
Service setting is required to display [08 Trimmer Receiver Adj.] on the screen. Contact your service repre-
sentative, if desired.
1
Press [Adjustment] on the Machine Screen to display the Adjustment Menu Screen.
2
Press [03 Finisher Adjustment], [06 Saddle Stitcher Pos. Adj.], and [08 Trimmer Receiver Adj.] in se-
quence.
The Trimmer Receiver Adjustment Screen will be displayed.
3
Select [700 times], [500 times], or [300 times] for Trim Count.
4
Select [1.0 mm], [1.5 mm], or [2.0 mm] for Move Pitch.