2 [02 half-fold stopper adj, 02 half-fold stopper adj.] -65 – Konica Minolta bizhub PRESS C8000e User Manual
Page 383
bizhub PRESS C8000/e
9-65
9.9
[03 Finisher Adjustment] (Finisher FS-612)
9
11
Press [Return] to restore the Finisher Adjustment Menu Screen.
9.9.2
[02 Half-Fold Stopper Adj.]
Adjust the misalignment in edges of output sheets for each paper size if needed, when using Finisher
FS-612.
Objects of adjustment: Full Area, A3 w, B4 w, SRA4 w, A4 w, 12 e 18 w, 11 e 17 w, 8.5 e 14 w, 8.5 e 11 w,
8.125 e 13.25 w, 8.5 e 13 w, 8.25 e 13 w, 8 e 13 w, 8K w, 16K w, Custom (380-460 mm), Custom (220-
379 mm)
1
Press [Adjustment] on the Machine Screen to display the Adjustment Menu Screen.
2
Press [03 Finisher Adjustment] and [02 Half-Fold Stopper Adj.] in sequence.
The Half-Fold Stopper Adjustment Screen will be displayed.
3
Select the size to be adjusted using [+] and [,] to scroll.
4
Press [Print Mode].
5
Load the paper size to be adjusted into a tray, then select that tray key.
6
Press Start on the control panel. A sample pattern will be output.
7
Check the misalignment (a) of the edges of output sheet.
Allowance: a = 0 +/- 1 mm
8
If any adjustment is required, press [Exit Print Mode] to return to the Half-Fold Stopper Adjustment
Screen.
9
Use the touch panel keypad or control panel keypad to enter the setting data.
% Use [+/-] to specify the value to be positive or negative.
% Press [Set] to change the current data.
% Adjustable range: -128 (Long) to +127 (Short) (1 step = 0.1 mm)
% If misalignment appears as shown above, enter a negative value.
10
Repeat the steps from 4 to 9 until the desired result is obtained.
11
Press [Return] to restore the Finisher Adjustment Menu Screen.