Rockwell Automation 1785-Lxxx Enhanced and Ethernet PLC-5 Programmable Controllers - Manual (Page 208)

Publication 1785-UM012D-EN-P - July 2005
11-34 Communicating with Devices on an Ethernet Network
Interpreting Ethernet Status
Data Monitor the status of Ethernet PLC-5 controllers by accessing the Ethernet
channel 2 status screen of your programming software. The diagnostic counter
data displayed is stored in the diagnostic file defined on the Ethernet channel 2
configuration screen.
9000 Remote node cannot buffer command
B000 Controller is downloading so it is inaccessible
F001 Controller incorrectly converted the address
F002 Incomplete address
F003 Incorrect address
F006 Addressed file does not exist in target controller
F007 Destination file is too small for number of words requested
F00A Target controller cannot put requested information in packets
F00B Privilege error, access denied
F00C Requested function is not available
F00D Request is redundant
F011 Data type requested does not match data available
F012 Incorrect command parameters
F01A File owner active – the file is being used
F01B Program owner active – someone is downloading, online
editing, or set the program owner with APS in the WHO
Active screen
Code - Hexadecimal
(word 1 of the control block) Description
(displayed on the data monitor screen)