Rockwell Automation 1785-Lxxx Enhanced and Ethernet PLC-5 Programmable Controllers - Manual (Page 25)

Publication 1785-UM012D-EN-P - July 2005
Understanding Your Programmable Controller 1-7
PLC-5/40E and -5/80E Controller Front Panels
PLC-5/40E
Programmable
Controller
Use this port with ASCII or DF1 full-duplex, half-duplex
master, and half-duplex slave protocols. The port's
default configuration supports controller programming:
channel 0-25-pin D-shell serial port; supports standard
EIA RS-232C and RS-423 and is RS-422A compatible
one stop-bit
BCC error check
no handshaking DF1 point-to-point
2400 bps
no parity
battery indicator (red when the battery is low)
controller RUN/FAULT indicator (green when
running; red when faulted)
force indicator (amber when I/O forces
are enabled)
channel 0 communication status indicator
(green when the channel is communicating)
Install memory module here
Use these labels to write information about the
channel: communication mode, station addresses etc.
Install battery here
channel 1B status indicator (lights green and red)
PLC-5 family member designation
keyswitch; selects controller mode
channel 1A communication port; its default
configuration is DH+ communication
8-pin mini-DIN, DH+ programming terminal
connection parallel to channel 1A
channel 2 Ethernet status indicator (green when
functioning normally; red when not functioning)
channel 2 communication port;
a 15-pin Ethernet port
channel 1A status indicator
(lights green and red)
channel 2, Ethernet transmit indicator (green when
the channel is communicating)
channel 1B communication port; its default
configuration is remote I/O scanner
Channel 0 is optically-coupled (provides high electrical noise immunity) and can be used with most RS-422A
equipment as long as:
termination resistors are not used
the distance and transmission rate are reduced to comply with RS-423 requirements
Configure these 3-pin ports for:
remote I/O scanner
remote I/O adapter
DH+ communication
unused
2
2
2
1
1
external transceiver fuse