Buhler 2425 - Manual (Page 101)

SECTION 2 - OPERATION
2-43
Position Three - “Roadway Use” - When the
rotary switch is in this position, the front and rear
roof-mounted amber warning lights and the
taillights mounted on the rear fenders will
continue to work as described in position two (as
will the wide transport marker lights). In addition,
the left and right outermost headlights, 1,
mounted above the front grille, will be lit.
The grille-mounted headlights are adjustable left
and right, and up and down, without loosening
any hardware.
The background lights on the operator’s control
panel behind the engine oil pressure and engine
coolant temperature gauges, as well as the
background light behind the fuel gauge and
powershift gear display, if equipped, mounted on
the right front cab post, will light. The small amber
console light on the right front cab post under the
fuel gauge, and the background light in the
performance monitor display window will also be
lit.
NOTE: If the multifunction switch is put in the
“High/Low Beam” position, the right and left
inner headlights mounted above the front
grille will turn off and on, depending on beam
selection.
When the high beam position is selected, a
blue indicator light will light on the warning
light bar indicating that the high beams are
on.
WARNING: FOR YOUR PROTECTION, USE
THE HAZARD WARNING LIGHTS WHEN
TRAVELING ON PUBLIC ROADS, UNLESS
PROHIBITED BY LAW
Figure 2-60
1 1