Buhler 2425 - Manual (Page 93)

SECTION 2 - OPERATION
2-35
QUAD SHIFT III SHIFTING
Range Shifting
1. Be sure the engine speed is below 1700
RPM. Whenever possible, reduce engine
speed to idle.
2. Depress the clutch fully and bring the tractor
to a complete stop. Place the range shift
lever, 1, in neutral. Wait three to four seconds
to allow the gears to slow down to a near
stopped condition. Select the desired range.
Shift pattern decals, 2, are located behind the
shift lever indicating range position. A decal
on the right cab window gives the range and
gear position for speed selections based on
tire size options.
3. If you are not able to move to the desired
position, turn the steering wheel to the left or
right to allow gears to mesh.
4. Slowly release the clutch pedal to achieve a
smooth start.
5. Reset the engine speed to operating range.
The range shift decal located behind the range
shift lever displays the position the range shift
lever should be in for high (H), medium (M), low
(L), or reverse (R) range.
2
1
Figure 2-50
Figure 2-51