Buhler 2425 - Manual (Page 201)

SECTION 2 - OPERATION
2-143
Category Conversion
The hitch is shipped in the Category IV Narrow
position. To convert the hitch to the Category III
position (implement side), proceed as follows:
Remove the pin, 1, that attaches the lift link to the
lower link by removing the klick pin and washer
from inside the lower link.
Figure 2-201
1
Remove the lower links, 1, by removing the
locking plate bolt, 2, and locking plate, 3.
Remove the lower link attaching pin, 4, and
bushing.
Turn the lower links end over end and attach the
lower link to the tractor using pin, 4; locking plate,
3; and bolt, 2. Store the bushing on the storage
pin.
Figure 2-202
2
3
4
1
Reattach the lift link to the lower link, using the
rearmost hole on the lower link, with the klick pin
and washer.
Repeat this procedure for the other side of the
hitch.
Figure 2-203