Buhler 2425 - Manual (Page 204)

SECTION 2 - OPERATION
2-146
IMPLEMENT CONNECTION
With the levers, 1, horizontal and the safety pins,
2, in the storage position, back the tractor up to
the implement. Using the manual raise/lower
switch, couple the quick hitch to the implement.
Figure 2-209
2
1
When the lower links are seated properly, insert
the safety pins, 1, to lock the spring-loaded
latches in place.
WARNING: WHENEVER AN IMPLEMENT IS
ATTACHED TO THE QUICK HITCH, USE THE
SAFETY PINS. IF THE SAFETY PINS ARE
NOT IN PLACE, THE POSSIBILITY OF
INADVERTENT DETACHMENT EXISTS,
PARTICULARLY DURING TRANSPORT.
Figure 2-210
1
IMPLEMENT DISCONNECT
Lower the implement to the ground where you
want to disconnect. Be sure the implement is
sitting in a secure position and will not shift or tip
when disconnected from the quick hitch.
Remove the safety pins, 1, and move the lever, 2.
to a vertical position. The implement is now
attached only by the top link. Using the manual
raise/lower switch, lower the 3-point hitch to
clear the top link pin.
Figure 2-211
2
1