Buhler 2425 - Manual (Page 203)

SECTION 2 - OPERATION
2-145
Quick Hitch Installation
(Optional - Category III/IVN)
CAUTION: BE SURE NO ONE IS BETWEEN
THE IMPLEMENT AND TRACTOR WHEN
BACKING UP.
An optional quick hitch is available to attach to
the Category III/IVN 3-point hitch that allows
quick attachment of implements to the tractor. To
use the quick hitch, proceed as follows:
The 3-point hitch can be set for Category III or
Category IVN with the quick hitch. If Category III
is used , it will be necessary to remove the
bushings in the link pins. The quick hitch uses
Category IVN pins.
Connect the quick hitch, 1, to the upper and lower
hitch points of the 3-point hitch with pins and
cotter pins.
Figure 2-207
1
The upper implement attaching point of the quick
hitch must be positioned properly for either a
Category III or a IVN implement. Remove the
eight attaching bolts, 1, from the quick hitch
frame and position the bracket properly for the
implement to be used.
NOTE: When Category III implements are
attached to the quick coupler, proper
bushings must be used to adapt the coupler
to the implement. The coupler attaching
points are set up for Category IV implements.
Figure 2-208
1