Buhler 2425 - Manual (Page 296)

SECTION 3 - LUBRICATION AND MAINTENANCE
3-72
AS REQUIRED
OPERATION 70
Check the Windshield Washer Fluid
To replenish the windshield washer fluid, turn the
latch on the SMV sign on the rear of the cab.
Allow the sign to pivot outward. Remove the lid,
1, on the reservoir and add fluid as necessary.
Figure 3-118
1
OPERATION 71
Change the Windshield Wiper Blades
The front and rear windshield wiper blades can
be changed using the following procedure:
Pivot the wiper arm outward away from the
window. Remove the blade bolt, 1, from the
center of the blade. Install the new blade and
reinstall the center bolt.
Figure 3-119
1
The front windshield wiper blade is 457 mm (18″)
long and the rear wiper blade is 660 mm (26″)
long.
The small screws, 1, can be loosened to adjust
the blade angle, which should be parallel to the
edge of the window. Retighten the screws when
the blade is adjusted properly.
Figure 3-120
1