Buhler 2425 - Manual (Page 198)

SECTION 2 - OPERATION
2-140
Place the upper link in the appropriate hitching
point on the upper link bracket. The top hole, 1, is
for Category III or IV implements. The bottom
hole, 2, is for Category III implements only.
Figure 2-193
1
2
To store the upper link, remove the two small
hairpin clips, 1, that attach the storage bracket, 2,
to the upper link bracket, and pull the bracket
away from the tractor. Swing the upper link
upward and reinstall the bracket and clips.
Figure 2-194
2
1
Shims
Shims, 1, prevent the lower links from contacting
the tires when the lower links are not connected
to an implement and are free to move side to
side. Use shims so that the lower links do not
contact the tires when in their maximum sway
position, or when the links are unhooked from the
implement.
Shims can be removed or installed by removing
the two bolts that hold the shims in place.
Tractors are shipped from the factory with
approximately 25.4 mm (1″) shim packs
installed.
Figure 2-195
1