Buhler 2425 - Manual (Page 252)

SECTION 3 - LUBRICATION AND MAINTENANCE
3-27
EVERY 10 HOURS OR DAILY
OPERATION 19
Lubricate the Rear Drag Link Pins
Lubricate the top two grease fittings, 1, remotely
mounted on the left rear frame, until grease flows
from around the pin seals. This will purge any dirt
accumulated in the pivot pin area.
Use Moly based EP high temperature grease
available from your Buhler Versatile dealer.
Figure 3-34
1
OPERATION 20
Lubricate the Rear Axle Drive Shaft Steady
Bearing
Lubricate the grease fitting, 1, until grease flows
from the bearing area. This will purge any dirt
accumulated in this area.
Use lithium base EP high temperature grease
available from your Buhler Versatile dealer.
Figure 3-35
1
REMINDER
For the first week of operation all wheel mounting
hardware should be re-tightened to the specified
torque after the first hour of operation, then after
every three hours of operation for the first day.
Re-tighten to the specified torque daily until
wheel hardware maintains specified torque.
Refer to pages 3-79 thru 3-87.