Buhler 2425 - Manual (Page 259)

SECTION 3 - LUBRICATION AND MAINTENANCE
3-34
EVERY 250 HOURS
Fill the engine with oil to the proper level as
indicated by the dipstick. The capacities of the
engines are as follows:
2290, 2335, 2375 (QSM11)
Oil Pan Capacity - 34 L (9.0 gals.)
Filter Capacity - 2.7 L (0.7 gal.)
2360, 2425 (N14)
Oil Pan Capacity - 36 L (9.5 gals.)
Filter Capacity -2.7 L (0.7 gal.)
Buhler Versatile and Cummins Engine Co.
recommend the use of a high quality 15W-40
multi-viscosity oil for most applications.
Available from your Buhler Versatile dealer.
NOTE: The engine is filled with 10W-30 oil at
the factory. This weight oil aids in cold-
weather starting at the manufacturing
facility. SAE 15W-40 oil as listed is the
preferred viscosity oil for normal operation.
Operate the engine at idle speed to inspect for
leaks at the filters and drain plugs.
NOTE: Engine oil pressure must be
indicated on the Electronic Instrument
Control System within 10 seconds after
starting. If oil pressure is not registered
within 10 seconds, shut off the engine
immediately to avoid engine damage.
Confirm the correct oil level in the oil pan.
Shut off the engine. Wait approximately five
minutes to let the oil drain from the upper parts of
the engine. Check the oil level again.
Add oil as necessary to bring the oil level to the
“H” (High) mark on the dipstick.
IMPORTANT: Discard used engine oil
according to local laws and regulations.