Buhler 2425 - Manual (Page 114)

SECTION 2 - OPERATION
2-56
PTO Speed - The lower half of the display will
show the speed at which the PTO shaft is
turning based on the engine RPM. The letters
“PTO” will also be displayed in the lower right
corner of the lower display.
The readout value shown for PTO speed is a
factor of engine speed and is automatically
calculated by the electronic monitor. There is
no sensor on the tractor reading actual PTO
output speed.
Figure 2-83
Tractor Ground Speed - The lower half of the
display will show the true ground speed (if
equipped with optional radar unit) and the
radar symbol, or calculated ground speed
(unit less radar option). The display will read
km/h or MPH on the right side of the lower
display based on the unit of measurement
selected by the operator (see “Calibrating the
Electronic Control Instrument System” later in
this section for unit of measurement
selection).
Figure 2-84
If the tractor is equipped with the optional
radar unit, the radar symbol, 1, will also
appear on the lower display indicating that the
value shown is a true ground speed. If the
radar symbol is not shown, then the ground
speed is being calculated by the monitor
based on a sensor signal on the transmission
output shaft.
The value shown will be to the tenth of the unit
of measurement, MPH or km/h, as selected
by the operator.
Figure 2-85
1