Buhler 2425 - Manual (Page 285)

SECTION 3 - LUBRICATION AND MAINTENANCE
3-61
EVERY 1500 HOURS OR YEARLY
On the Model 2360 and 2425 (N14), check the
exhaust pipe to turbo outlet clamp, 1, and the
compressor housing to turbo body clamp, 2.
Torque the clamps to 8 N⋅m (72 in. lbs.). Torque
the lower oil drain line cap screws, 3, to 27 N⋅m
(20 ft. lbs.). Make sure the upper oil line fitting, 4,
is tight.
Tighten the four nuts that mount the turbocharger
to the exhaust manifold of the engine to 65 N⋅m
(50 ft. lbs.).
If any oil leaks or broken connections are found,
contact your Buhler Versatile dealer.
Figure 3-98
1
3
2
4
OPERATION 58
Check the Radiator and Heating System
Hoses
Check the upper and lower radiator hoses, 1, for
deterioration due to heat or contact with other
engine components. Inspect the heater hoses, 2,
for any wear or damage.
If any hoses in the engine cooling system or
tractor heating system require replacement,
contact your Buhler Versatile dealer.
Figure 3-99
1
2
OPERATION 59
Check the Cab Mounts
The cab is mounted on four rubber mounts in
each corner of the cab.
Check the mounts, 1, for wear or deterioration
and torque the mount bolt and nut to 217 N⋅m
(160 ft. lbs.). Torque the bolts, 2, that hold the
mounts to the frame to 97 N⋅m (72 ft. lbs.).
If the mounts require replacement, contact your
Buhler Versatile dealer.
Figure 3-100
1
2