Buhler 2425 - Manual (Page 261)

SECTION 3 - LUBRICATION AND MAINTENANCE
3-36
EVERY 250 HOURS
OPERATION 28
Check the Engine DCA4 Protection Level
The DCA4 protection level must be checked
whenever coolant is added to the cooling system
or whenever the cooling system filter is changed.
Buhler Versatile has a test kit available, part
number FGCC2602, to check the concentration
level. Instructions are included with the test kit.
Contact your Buhler Versatile dealer to obtain
the test kit.
Follow the instructions in the kit to maintain
proper DCA4 protection level.
Figure 3-46
OPERATION 29
Change the Fuel Filter
The fuel filter is located on the left side of the
engine. To replace the fuel filter, 1, unscrew it
from its filter head, 2, and discard the old filter. Fill
the new filter with clean fuel and install it onto the
filter head. Hand tighten the filter 1/2 to 3/4 of a
turn after the seal on top of the filter contacts the
filter head.
IMPORTANT: Discard the used fuel filter
following local laws and regulations.
NOTE: There is no shutoff provided at the
filter head to stop the flow of fuel from the
tanks. The filter head is located high enough
on the engine so that no fuel should escape
when the filter is removed.
Figure 3-47
1
2