Buhler 2425 User Manual
Page 255
SECTION 3 - LUBRICATION AND MAINTENANCE
3-30
METHOD B
1 Soak the filter for 15 minutes in warm water
containing a mild detergent.
2 Rinse the filter with running water below 1.4
bar (20 PSI).
3 Shake off excess water and allow to air dry.
IMPORTANT: Do not attempt to dry the filter with
heat or compressed air and do not install until
thoroughly dry as the filter may rupture. It is
recommended that a new filter is installed at this
service and the washed one put aside for
installation at a subsequent service. Store the
spare filter in a dry place and wrap it to prevent
dust contamination or damage.
NOTE: Wash the filter more frequently when
operating in extremely dusty conditions.
NOTE: Replace the filter when holes or tears are
visible.
NOTE: The element may be washed a maximum
of 10 times.
Reinstall the element into its frame and check the
seal, 1, around the perimeter of the element for
nicks or cracks. Replace the element if any
damage is found.
Clean the filter with a damp, lint--free cloth.
Figure 3-39
1