Buhler 2425 - Manual (Page 295)

SECTION 3 - LUBRICATION AND MAINTENANCE
3-71
AS REQUIRED
OPERATION 67
Adjust the Decelerator Pedal Setting
The decelerator pedal, when pushed, reduces
the engine speed to a set speed. Move the hand
throttle to Full Throttle and depress the
decelerator pedal. The engine RPM should drop
to a consistent set speed.
NOTE: The suggested decelerator speed
setting is 1400 engine RPM.
To increase the decelerator RPM setting, turn the
adjusting bolt, 1, on the bottom of the pedal
counterclockwise. To decrease the RPM setting,
turn the bolt clockwise. Figure 3-116
1
Proper operation of the decelerator will let the
throttle lever, 1, stay in the preset position when
the decelerator is depressed. If the throttle lever
moves rearward, tighten the nut on the lever. The
nut can be reached through slot, 2. Tighten the
nut 1/4 turn at a time until proper operation is
achieved.
OPERATION 68
Clean the Cab Floor
Keep the cab floor free of dirt and debris that may
cause an obstruction or safety hazard, especially
around the brake and clutch pedal area.
The cab floor should be kept clean by periodically
vacuuming or sweeping, and washing.
The floor mat can be removed from the cab floor
by rolling it away from the walls of the cab and
pulling it upward and away from the floor. The
floor mat is a two-piece rubber mat that can be
washed using a mild detergent.
OPERATION 69
Clean the Cab Seat and Upholstery
When the soft trim material and seat become
dirty, they should be wiped clean. Dip a cloth in a
warm water/detergent solution and wring out as
much of the water as possible. Wipe the interior
material with the damp cloth.
The interior molding inside the cab can be
cleaned with a water/detergent solution as
needed.
Figure 3-117
1
2