Buhler 2425 - Manual (Page 103)

SECTION 2 - OPERATION
2-45
Cab Dome Light
The cab dome light, 1, mounted on the upper left
side of the cab, has a three-position control
switch, 2. The light switch functions as follows:
Center - Light is off.
Bottom - Light is on constantly.
Top - Light is on only when the cab door is open.
Light will turn off when door is closed.
Figure 2-63
1
2
Trouble Light
A trouble light, 1, is located in the left, rear corner
of the cab, under the rear shelf. The light has an
5.5 m (18′) cord attached to it that can be reeled
in and out using the crank handle, 2. To remove
the light, flip the lever, 3, downward and pull the
light from the receptacle.
The light switch, 4, is a two-position switch. With
the switch lever in the off position (horizontal),
the light is off. With the switch lever in the on
position (vertical), the light is on as long as the
cab door is open. When the cab door closes, the
light goes out.
The trouble light is used in conjunction with the
cab dome light to illuminate the cab interior when
the cab door is open.
To put the trouble light in the storage position,
reel the cable all the way in with the crank handle,
2, insert the light into its socket, and flip the lever,
3, upward to catch the small knob on the side of
the light.
Figure 2-64
1
2
3
4