Buhler 2425 User Manual
Page 82
SECTION 2 - OPERATION
2-24
Engine Block Heater
1. Block heaters are standard equipment on
Buhler Versatile tractors. The block heater
cord, 1, is located on the right side of the
engine.
2. A 3-wire 15-amp extension cord is required to
connect the block heater to a grounded 115-
volt electrical outlet.
WARNING: TO AVOID SHOCKS OR
OTHER INJURIES, NEVER USE AN
UNGROUNDED
OR
INADEQUATE
EXTENSION CORD. ALWAYS USE A
GROUNDED 3-WIRE EXTENSION CORD
WITH A 3-WIRE PLUG WHICH IS RATED
FOR AT LEAST A 15-AMPERE LOAD, AND
PROTECTED BY A SUITABLE FUSE OR
CIRCUIT BREAKER.
3. To operate the heater, plug the heater cord in
for at least four hours before attempting to
start. Maximum starting ability is usually
obtained within four hours.
4. Disconnect the cord when the engine has
started.
WARNING: ELECTRICAL SHOCK HAZARD!
BE
SURE CORDS
ARE
PROPERLY
GROUNDED; DO NOT HANDLE IF WET.
DO NOT PLUG THE HEATER IN IF NOT
IMMERSED
IN
COOLANT.
IT
MAY
OVERHEAT
AND
BURST
CAUSING
INJURY.
Figure 2-36
1